Work report > Experiment report

Experimental report writing requirements


Experimental report writing requirements


1. The experimental report and the experimental preview report use the same experimental report paper, which can be completed by continuing to supplement the relevant content on the basis of the preview report. It is not necessary to repeat the work, so it is necessary to first make the preview report comprehensive and comprehensive.

2. According to the experimental requirements, when the experiment is carried out in the laboratory during the experimental time, the experimental data is recorded while measuring. However, in order to make the report accurate and beautiful, the experimental measurement data should be recorded on the draft paper at this time. Wait until the report is finished and then copy it to the experimental report paper to avoid mis-filling the data, causing modifications and making the report messy.

3. In the experiment, if the experimental measurement data does not match the previous calculation value, or even the difference is too large, the reason should be found at the time, whether it is the original calculation error, or there is a problem in the measurement, it can not be ignored, this can only be regarded as This experiment was not completed.

4. The experimental report is not a simple experimental data recording paper. There should be an analysis of the experimental situation. The data measured by the experiment should be compared with the calculated value. If the error is small, it can be considered to be basically consistent. If the error is large, there should be an error analysis to find out the cause.

5. There should be experimental conclusions for each item in the experimental report, and conclusions should be drawn through specific experimental content and analysis of specific experimental data.

6. Design, comprehensive experiments should draw the designed circuit diagram, marking the selected and determined circuit parameters. Have a verification process and necessary design instructions.

7. If necessary, draw a curve. The curve should be scaled, the unit is fully labeled, the curve proportion is appropriate and beautiful, and the curve is correspondingly explained and analyzed.

8. At the end of the report, complete the questions to be answered on the instructions.

9. The experimental report should have the preliminary results and operational results given by the experimental instructor in the experiment, and have the signature of the instructor, otherwise the report will be invalid.

10. I hope that each student can complete the experimental report carefully. This is an important part of the training and training of comprehensive and summarizing ability. It is a foundation for the design of curriculum design and graduation design papers, and it is also beneficial for future work and scientific research. of.

Beijing Institute of Petrochemical Technology

Electrical and Electronic Teaching and Experiment Center

recommended article

popular articles