Locksmith safety operation procedures

1. Before the work, it is necessary to strictly check whether the tools are complete and reliable, and whether the safety facilities of the work unit are complete and firm.

2, the use of a variety of hoes can not be quenched and can not be directly hit the workpiece with a hammer, with a wooden or soft metal padding.

3. When using a sledgehammer or a hammer, check whether the hammer is firm. Do not wear gloves when hammering.

4. When using the hand-held power tool, check for leakage. When working, connect the leakage switch, and pay attention to protect the conductive cord to avoid electric shock. Do not wear gloves when using the drill.

5. Do not put your hand into the through hole of the two pieces of workpiece connection to prevent the workpiece from shifting and crushing the finger.

6. Before the equipment is tested, it is necessary to inspect the rotating parts and electrical parts in detail to meet the installation requirements, and issue warnings to the personnel present, and then test the machine according to the written instructions.

7, electrical equipment failure repair must find a maintenance electrician, is not allowed to arbitrarily remove the socket, plug, do not allow the wire to be directly inserted into the socket.

8, ascending the work to first check whether the ladder is strong, smash the seat belt, tool materials are not allowed to be placed directly on the movable facilities such as the ladder, so as not to injure people.

9. The work site should be clean and tidy, and the disassembled parts should be stored well and do a good job in civilized production.

Note 1: Refer to and implement the corresponding regulations for the safe operation procedures of the lathe, planer, miller and miller.

Note 2: The safe operation of motor vehicle drivers complies with the unified regulations of the public security and transportation administration departments.